Drill Bits

Use one of these Masonry drill bits to create pilot holes into hard earth to help the deployment of your longer GroundGrabba Pro I or Pro II or commercial range GR14's.

What You Get

Your choice of:

• 1x 12mm x 300mm Masonry Drill with HEX shaft / shank
• 1x 12mm x 600mm Masonry Drill with HEX shaft / shank
• 1x 12mm x 600mm Masonry Drill with SDS shaft / shank
• 1x 15mm x 900mm Masonry Drill with SDS shaft / shank

Specifications

300mm Model

• 12mm x 300mm
• 12mm Masonry Drill Bit to pre-drill holes into very hard ground to help make the insertion of GroundGrabba Pro possible.
• Made of hardened steel with a tungsten tip.
• Speed Hex clip in style shank

Weight: 175 grams
Dimensions: 12 × 300mm

 600mm Models

Hex Speed Shank

• 12mm x 600mm
• 12mm Masonry Drill Bit to pre-drill holes into very hard ground to help make the insertion of your GroundGrabba Pro, Pro I or Pro II possible.
• Made of hardened steel with a tungsten tip.
• Speed Hex Clip in style shank

Weight: 250 grams
Dimensions: 12mm x 600mm

 SDS Shank 

Weight: 250 grams
Dimensions: 12mm x 600mm

 900mm Model

 SDS Shank 

Weight: 400 grams
Dimensions: 12mm x 600mm

Additional Information

If you go camping on really hard compact ground and you’re finding it almost impossible to drive your GroundGrabba Pro, Pro I or Pro II into the ground then try pre-drilling the ground using this 12 x 600mm masonry drill bit.

You may need to drill the ground an inch or two at a time and keep clearing the hole if the ground is ‘that’ hard.  Perhaps you may also need to widen the hole too.

Video

Disclaimer

⚠ Caution:

❌  Do not use in grounds where there are underground services such as but not limited to: electricity, gas, phone, data, water. 

❌  Do not use GroundGrabba products for any other purpose other than ground anchoring.

• Misuse or abuse of GroundGrabba products can lead to injury or worse to the user or bystanders. 
• Not to be used with mains powered drills. 
• When using Battery drills please refer to the drill manufacturers warnings and safety instructions prior to use with GroundGrabba products. 
• Only use GroundGrabba products for their intended purpose of ground anchoring things such as tents and shade canopies. 
• Always hold your drill firmly with both hands and use the inside of your legs as a drill guide with the drill handle in between your legs to help prevent torque twisting wrist or other injury. 
• Always start your drill on the lowest torque setting. 
• Use a good quality high torque drill or impact wrench. 
• For hard or extremely hard grounds we recommend pre drilling a minimum of a 12mm pilot hole to help with insertion.
• Some grounds will be impenetrable. 
• Use the correct GroundGrabba for the job. 

Warranty

Masonry Drills come with a twelve month manufacturer defect replacement warranty

*conditions apply